2006 Owner's Manual - Troubleshooting Guide
Troubleshooting Guide
This guide will assist in solving simple problems with the spa. If the problem cannot be solved using these procedures, contact your authorized Bullfrog Spa dealer.
Control panel displays an error message:
Cause: An error has occurred.
Solution: See Diagnostic Messages for specific errors.
Control pad and spa equipment do not operate:
Cause #1: No electrical power to spa.
Solution: Turn on or reset the GFCI circuit breaker. If this does not solve the problem, have a qualified Electrician check the electrical service.
Cause #2: The 20 or 30A fuse, depending on the system, has blown.
Solution: Contact your authorized Bullfrog Spa dealer.
GFCI breaker trips repeatedly:
Cause #1: Improper wiring to spa or GFCI breaker is defective.
Solution: Consult with a qualified Electrician.
Cause #2: There is a defective component on the spa.
Solution: Contact your authorized Bullfrog Spa dealer.
Spa pump turns off during operation:
Cause #1: Automatic timer has completed its 30 or 120 minute cycle.
Solution: Turn on the pump.
Cause #2: Pump has overheated due to the vents on the equipment door being blocked.
Solution: Clear items away from vents.
Cause #3: The pump motor is defective.
Solution: Contact your authorized Bullfrog Spa dealer.
Spa will not heat:
Cause #1: Slice valve is partially or fully closed.
Solution: Open slice valve and secure with valve keeper.
Cause #2: Thermostat has been turned down.
Solution: Adjust thermostat to desired temperature.
Cause #3: High limit sensor has tripped.
Solution: Press any button to reset.
Cause #4: Heating system is defective.
Solution: Contact your authorized Bullfrog Spa dealer.
Spa light does not work:
Cause #1: Light bulb has burned out.
Solution: Replace light bulb.
Cause #2: Lighting system is defective.
Solution: Contact your authorized Bullfrog Spa dealer.
Spa pump will not turn on, creates a burning smell while running, or makes excessive noise while running:
Cause: Pump motor is defective.
Solution: Contact your authorized Bullfrog Spa dealer.
Jets surge on and off:
Cause: Water level is too low.
Solution: Adjust water to the water level indication mark on the faceplate of the filter assembly.
Jets are weaker than normal or do not work at all, but the pump is running:
Cause #1: Jet handle(s) are partially or fully closed.
Solution: Open jet handle(s).
Cause #2: Filter cartridge is dirty.
Solution: See Cleaning the Filter.
Cause #3: There is air trapped in the spa equipment or its face piping.
Solution: Open the air bleed valve on each pump’s housing and allow air to bleed out of the system. Be sure to tighten each air bleed valve as soon as water starts to flow.
Cause #4: The suction fitting(s) are blocked.
Solution: Remove any debris that may be blocking the suction fitting(s).
Cause #5: The JetZone Divider™ is not installed (if applicable).
Solution: Re-install in the appropriate JetPak™.
NOTE: Running the spa without a JetZone Divider can cause serious damage to the pumps.
Cause #6: Slice valve is closed.
Solution: Open valve and secure with valve keeper.
|
